How To Install Laminate Flooring In A Mobile Home

Installing Laminate Flooring in Mobile Homes

Installing laminate flooring in mobile homes can exist more challenging at times. Some of the differences betwixt mobile homes and regular homes are door jambs, sub floors and in the older mobiles the walls, they tin be pretty flimsy.

Other problem areas are the joint where double wide mobile homes are joined together. This can be a problem when the joint is not flush from one side to the other.

Another outcome is removing the old vinyl flooring (or linoleum) from your mobile dwelling then you can install laminate flooring. I have seen in numerous mobile homes where the vinyl flooring was installed at the factory. The process they use is to install the vinyl flooring first and then install walls and cabinets on summit of it. Well-nigh of the time they do not glue information technology, it is simply laying on the sub floor. They also apply huge staples around the parameter to concord the vinyl in place. This creates a hump, and can touch on the laminate floor when installed over it. If you are simply installing the laminate flooring in the kitchen and non going over the stapled edge information technology isn't a problem, but if y'all are going over it and then its best to remove it.

Also when installing quarter round in mobile homes it can be a little different. In the older mobile homes they use a thin trim to cover the joints between the wall boards. They besides united states a corner trim where the wall boards meet at the corners. these trims need to exist cut so the quarter round will fit flat against the wall.

They accept changed the mode mobile homes are made over the years. In the old days they used to use particle board for the sub floor and install carpet and vinyl earlier they installed the walls. The walls were installed right on peak of the floor. The particle board would swell up if information technology got wet and then fall apart.

Even now when I install laminate in mobile homes I run beyond a lot of these older ones.

Here is an case of a door jamb in a mobile home. In this photo The bodily width of the door jamb is less then i/4 of an inch. You lot need more room under the door jamb for the expansion of laminate flooring when installing laminate flooring in mobile homes.

Installing Laminate Floor in Travel Trailers

Installing Base Board or Quarter Round in Mobile Homes

Even installing base of operations board in some cases can make you terminate and think. Here is ane I ran beyond recently. The mobile home I was working in had a room improver that was previously a screened in porch. When they converted it to a room the metallic frame piece of work was left behind the walls. They had to use metal screws to attach the paneling. And of course the screws are right where the base lath needs to go.

In the photo in a higher place I had to glue the base board to the sheet metallic walls. I used a white adhesive caulk which works good and fills in any little gaps. It also cleans upwards with water, only use a wet rag while the caulk is nonetheless wet. Notice how I use anything with weight to hold the base lath in place until the glue drys.

FAQ near anything that has to do with laminate flooring

I try to list answers to my readers questions about laminate flooring. I'm sure there are many that I miss, and so if you have a question about annihilation at all that has to do with laminate flooring feel free to postal service it here. I volition answer your questions based on my noesis every bit a laminate flooring installer. Hopefully it volition help you and other readers.

What Other Visitors Have Said

Click below to run into contributions from other visitors to this page...

Return to Dwelling Page

Source: https://www.laminate-flooring-installed.com/installing-laminate-flooring-in-mobile-homes.html

Posted by: martinezclinking.blogspot.com

Share this post